🏅 Dji Phantom 3 Professional Camera Not Working

23. Feb 3, 2021. #1. Hi, my I have just dug out my Phantom 3 Standard, and it is on firmware 1.0.14+. When I open DJI GO, it tells me I need a firmware update, whenever I try to do it, it always says no SD card. I have tried formatting it as Fat32, buying an entirely compatible Sandisk 64GB sd formatted as exFat, testing the gimbal's ribbon Aug 10, 2015. #1. I have the phantom 3 professional with the latest 1.3.20 firmware on it. I run either a Galaxy S5 or Galaxy Tab 4 7" tablet with the 1.2.0 DJIPilot app on it. I am having an issue with the drone not taking pictures when you click on the shutter button in the app, or click the button on the remote control. Naza-M Lite. Naza-M V2. WooKong-M. A2. Phantom 1. Phantom 2. Phantom 2 Vision. At the DJI Download Center, learn and download DJI WIN Driver Installer. Battery Not Detecting Charger. To force the battery to be in charging mode, press the battery button once and then immediately press and hold it down. Each LED will turn on until they’re all on. Once they are all on, some will turn off and then the current battery charge level will be displayed. Plug the battery into the charger. Offline. 5#. Make sure all the firmware are the latest version; hold the reset button on the range extender for three seconds to reset it, connect to the wifi again, rebinding the camera, and test the video preview again. 2014-11-30. kenargo Offline. kenargo. It takes 15-20 minutes for the aircraft, during that time you should hear 4 faint beeps and the camera LED flash Red/Green. Then when it's finished you should hear 3 beeps and the camera LED will be solid Green. And you can verify what firmware you are on by looking in the general settings and scrolling down to About. If you have no power when you do the bypass then your board wifi board is fried. If it powers on, use a laptop and connect to it and ping 192.168.1.1, 192.168.1.2 and 192.168.1.10 (lower wifi board - known to fry). No it is not the perforated module and I will try that first thing tomorrow. thanks. Make sure you have both the controller and the intelligent battery charged, 3. Plug in your intelligent battery into your Phantom 3 Standard (don't turn on yet). 4. Install the DJI Go app on your mobile device. 5. Turn on your controller and turn your controller upside down. You will see a small tag that shows you the controllers wireless SSID YERyE.

dji phantom 3 professional camera not working